No products match that search.
Rolling mills, ladles and continuous casting run hot and abrasive. Reclamation keeps rolls, moulds and grabs in service between campaigns.
Common consumablesPropellers, shafts and seawater pumps face cavitation, corrosion and dissimilar joints made afloat.
Common consumablesBuckets, teeth, crawlers and drill strings work in rock. Build-up and hardfacing return them to profile on site.
Common consumablesCrusher hammers, kiln parts and separator plates face limestone abrasion end to end. Most of it is rebuilt in place.
Common consumablesMill rollers, cane knives and juice-side plant wear through every crushing season. Roller arcing is routine maintenance.
Common consumablesEngines, gearboxes, axles and chassis rails come in worn or cracked. Fleet workshops rebuild rather than replace.
Common consumablesLocomotive, wagon and permanent-way components repaired back to specification in the shed and at the depot.
Common consumablesRefinery vessels, exchangers and rotating equipment in high-temperature and corrosive service.
Common consumablesBoilers, coal mills and ash handling live with erosion, heat and fly-ash. Overlays stretch the run between outages.
Common consumablesA sugar mill runs on a short season and cannot stop for a rebuild. Cane fibre and grit wear the knives, the fibrizer and the roller surfaces; hot acidic juice eats condensers and pump bodies; cast trash beams crack under shock. Pick an area of the mill to see which components fail, how they fail, and the STANVAC range that puts them back to work.
Every mapped component across the sugar mill.
No match for that component. Tell us what you’re repairing and an application engineer will recommend a consumable.
Cane fibre, grit and field mud cutting into knives, fibrizer tips and roller surfaces.
Roller and trash-plate teeth rounding off until the mill stops gripping and extraction falls.
Hot acidic juice and vapour eating condensers, juice pumps and the pan-floor pipework.
Cast trash beams, housings and turbine casings split by shock loading or an overtightened mill.
Base metal, wear factor and a photograph — an application engineer comes back with the consumable, the parameters and the expected life gain.
